In-House Film Blowing for PE, PP, CPE, PO and POF Multilayer Film

In-house blown film for PE, PP, CPE, PO and POF multilayer structures, including five-layer coextruded POF with 50% or higher shrink rate. 7-15 day lead times.

Film blowing workshop with a multilayer coextrusion line and rolls of PE and PP film
In-house film blowing line with rolls of PE and PP film.
Short answer

Film blowing extrudes polymer melt through an annular die, inflates it into a bubble and collapses the cooled tube into flat multilayer film. PSF Packaging blows PE, PP, CPE, PO and POF structures in-house, including five-layer coextruded POF with a shrink rate of at least 50%, and feeds an integrated printing, slitting and bag-converting line with 7–15 day lead times.

When this process applies

Film blowing is the first step of our integrated production chain and is used when the customer specification calls for a particular resin blend, layer structure or gauge. Film is produced to the approved sample and slit in-house before printing and bag converting. Structures and gauges are per customer specification; we do not sell parent rolls as a general commodity.

Technical specifications

ResinsPE, PP, CPE, PO, POF
StructureMultilayer coextrusion; five-layer for POF
POF shrink rate≥50%
Film gaugePer customer specification; confirmed on sample approval
Layflat widthPer customer specification; confirmed on sample approval
Downstream processesPrinting, lamination, slitting, bag converting
Lead time7–15 days
Quality systemISO 9001 (2019); EU REACH (2022)

Where it is the right choice

  • PE, PP, CPE, PO and POF film for converted bags
  • Five-layer coextruded POF for shrink packaging
  • Multilayer barrier film for ESD and VCI products
  • Matte CPE structures for frosted retail bags
  • Custom layer structures locked at sample approval

Where it is the wrong choice

Stating this explicitly matters more than a capability list: if your requirement falls into one of these categories, a different structure or a different supplier is the right answer.

  • Single-layer commodity film sold as raw roll stock — we convert film into finished bags
  • Engineering films and specialty membranes outside our PE, PP, CPE, PO and POF resin set
  • Gauge or layer structures that have not been fixed at sample approval
  • Orders that need film only without downstream converting, which fall outside our integrated line

Process setup

  • In-house blown-film lines for PE, PP, CPE, PO and POF
  • Coextrusion capability up to five layers for POF
  • In-house slitting matched to downstream bag widths
  • Film specification locked against the approved sample
Film Blowing

Process questions

Which film structures can you blow in-house?

We blow PE, PP, CPE, PO and POF multilayer film in-house, including five-layer coextruded POF with a shrink rate of at least 50%. Layer structure and gauge are per customer specification and are fixed on sample approval before the production run.

Do you sell raw film rolls?

Film blowing is the first step of our integrated line, so the film we make normally goes straight into printing, slitting and bag converting. We do not trade generic parent-roll stock; finished bag formats and roll film for specific packaging lines are quoted against an approved specification.

How do you keep film consistent between repeat orders?

Resin blend, layer structure and gauge are recorded at sample approval and held as the production specification. That record is used for repeat orders across our small-batch and large-volume runs, supporting a 99.9%+ delivery pass rate.

Send your bag specification, get a quote

Give us the format, dimensions, film structure and artwork. You will receive an indicative price, a stated lead time and a clear answer on whether we can hold the specification — no obligation, and no sales call unless you ask for one.

Chat on WhatsApp